Thermal Dryer TT
Application
Neue Herbold Thermal Dryer TT Series is a down stream unit after the mechanical dryer. It is designed to achieve a final material moisture of 3% or less.
Technique
The material is fed through a cyclone. A heater supplies hot air on a continuous basis and is equipped with a temperature control unit. The required temperature is determined by the rest moisture of the various materials as well as the required through put rate. After completion of the drying process the material is blown into film silos (FS Series) or into big-bags for further treatment.
To guarantee an efficient energy consumption the heating zones of the Thermal Dryer are controlled in a sequential mode.
The standard dryer is supplied with an electrical heating aggregate.
Neue Herbold Complete Range
Two Shaft Shredder ZRM
Hammer Mills HM
Fine Grinding ZM
Pipe shredder HZR
Polystyrene Shredder RL
Bale breaker /Screw Shredder
Guillotine shears GS
Granulators LM/SM
Washing plants
Single Shaft Shredder HZR
Friction Washer FW
Dewatering Screw
Pre-Wash Screw
Pre-Wash Drum
Intensive Cleaner IW
Mechanical Dryer TM
Stage Dryer T
Thermal Dryer TT
Holding Silos FS
Round Silos
Suction Units
Separation Tank TB
Fines Separator HS
Cascade Sifter ZS
About Neue Herbold
Wastech Engineering, as the Australian agent for Neue Herbold, offers a complete program for the size reduction (granulators, grinders, pipe-granulators, profile-granulators, pulverizers, fine-grinders, screw-shredders, bale-breaker, hammer mills, shredders, polystyrene-shredders, guillotines, complete washing-lines) and preparation of plastic waste from production and plastic waste collection points.